Front Boost Adaptor - Chris King ISO Model:18mm

Front Boost Adaptor - Chris King ISO Model:18mmMachined in Whistler, Canada from stainless steel. Converts your 100mm front hub to Boost spacing, using an extended drive side end cap. You will also need to dish your wheel by 5mm to the drive side, to center your rim. Choose the 18mm option if your hub has the removable split type end cap on the drive side. This measurement refers to the diameter of the end of the hub axle without the end cap installed. Choose the 21mm option if your hub does not

A guide pin in the socket centre helps to keep the tool aligned and prevent any unwanted damage to your frame's hardware

These machined aluminum sleeves offer precision workholding that you'll only wish was available years ago

get in touch

With a much more elastic quality

Grip down low where its needed for turning by hand

1mm option

This measurement refers to the diameter of the end of the hub axle without the end cap installed

use a star nut installation tool to make sure the nut is properly aligned

Mess-free bleeding

How do you get that broken hanger off

jumps getting bigger or bikes simply getting ridden harder

correcting geometry and making your bike ride the way it should