Brush System Idler for Eliminator 224 & Clipper M-2B C3

Brush System Idler for Eliminator 224 & Clipper M-2B C3Eliminator 224 & Clipper M 2B Brush System Idler 5 8 diameter X 6. 5 long steel shaft. This shaft is standard on all eliminator seed cleaner brush systems. Note that this shaft would only be used on M 2Bs with updated gearbox brush drive systems.

or 68D require you to cut 1 brush into two pieces and install them on the smaller H frame carrier under the scalper screen

In stock except for the 49

This does not include the shafts

2 brushes will need to be purchased because the hopper is designed with both a front and a back brush

20x48 = 400-550

The bore is ¾”

two pillow block bearings

Clipper 7 series screen -34" x 42" with SLOTTED holes

5” wide X 4” high

The angle iron measures 9” X 2” X 2”

Note that this shaft would only be used on M-2Bs with updated gearbox brush drive systems

This pitman arm goes on the top shoe for a 248 BDH model