Wireless Remote Control Blox - Tx & Rx

Wireless Remote Control Blox - Tx & RxUsing Wireless Blox, you can control all your Blox in the WitBlox kit wirelessly. This control block allows you to control any output in the range of about 100 metres. You can connect 5 Inputs (Buttons & Sensors) & 5 Outputs simultaneously. You need 2 Power Blox to use Wireless Tx & Rx Note : Power Blox purchased before 31st May 2018 are not compatible with Wireless Blox. You need to get 2 new Power Blox

\nBattery(1)

\nInput Plug: 2-Pin EU type

This project Set contains:

Automatic Dishwasher

\nInput current (mA): 100

Single LED backlight included can be dimmed easily with a resistor or PWM

Holds four 18650 batteries

\n Motor power supply is 3-6V

This is LCD1602 Parallel LCD Display that provides a simple and cost-effective solution for adding a 16×2 Black on RGB Liquid Crystal Display into your project

convenient to use

\n Straw(11

and especially avoiding stall or slip