SCAR Triple Clamp Offset 22mm

SCAR Triple Clamp Offset 22mmSCAR triple clamps are manufactured by numerical control in high grade aeronautical aluminium (Aluminium 7075 T6). Very easy to install thanks to its shaft and pre mounted bearing. The upper triple clamp allows 4 different positions of the handlebars with stiffening mounts. Changes in offset improve directional stability and skill on bends. Sturdier and stronger More control and rigidity Fewer shocks and vibrations Anodized to prevent corrosion

Ze zijn lichter dan het origineel en zijn voorzien van een racing-design

3 Shell and EPS Sizes for a Personalized Fit

Ze zijn eenvoudig te monteren en zijn ideaal voor het reviseren van de motor op basis van het origineel

– Motul logo on left thigh pocket– Flexbelt® waistband stretches at the sides– Ergonomically designed knee section with stretch insert– Knee pad pockets– Pen compartment and phone pocket sewn onto the left– Folding ruler pocket with pen compartment outside on the right– Safety pocket with zip fastener– Hammer loop and folding ruler pockets inside on the left– Two inset pockets– Thigh pocket with flap– Two hip pockets

} Gasket for Montesa 4RT Titanium pipes

Connecting Rod Kit

a hose and a receiver cylinder

dimension tolerances

PERFORMANCE LINE

HOT RODS crankshaft bearing kit enable you to renew your connecting rod system

Aluminium cage made from a single block

and wear well over time