Gauge Wheel Arm Repair Kit John Deere 7000 Kinze 2000/3000 1/2 Bolt Discount-5

Gauge Wheel Arm Repair Kit John Deere 7000 Kinze 2000/3000 1/2 Bolt Discount-5PR1110: GWA Repair Kit JD 7000, Kinze 2000 3000 1 2" Bolt The gauge wheel arm pivot is the #1 wear point on planters. This is caused by the fact that the ground load on the gauge wheel is offset from the center of the row where the arm contacts the adjustable stop. This offset load is supported by two points of contact between the pivot pin and the bore of the hub. These points wear and the arm starts to lean allowing the tire to pull away from the

and unloads efficiently like a round bar concave

One Furrow Cruiser Complete Wheel with a Case IH 500T Bolt

•Ability to shim in and out with washers

operators’ speed is often limited by the concaves unloading most of the grain on the front right section of the sieves

RECEIVER TUBE FOR CASE IH 5310 STRIP TILL

causing our wheel to yield consistently better than similar products when tested side by side over several years

CCS4001: CCS Case IH Flagship Section Left

Inner tube only

Add this to the Nutrimate3 501L/R700 including (D

7300 & 1700 SERIES WITH 16" PARALLEL ARMS

This offset load is supported by two points of contact between the pivot pin and the bore of the hub

All lateral looseness is removed but the arm is still free to pivot